[. . . ] : -t\ :AI -g :::::::L\ TPS theft protection system (company card) 1. 1 Salety notiees and their . NOTEDraws attention t0 instructions and other useful information. It is essential that the operating instructions are read belore the TPS system is operated tor the tirst time. Always keep these operating instructions together with the TPS system. Ensure that the operating instructions are mBaning , , . 1. 2 Explanation of warning notices and olher symbols General warning with the TPS system when it is given to other Bersens. lllushation Z' \ General I warning @ Company carci @ TPS-K activation-key Read the Equipped vr with system 1fih , ^\ Lock symbol operating instructions before use. thell orotection E I These numbers refer to the corresponding illustrations. The illustrations can be found on the foid-out cover pages. [. . . ] Complete the code setting operation by disconnecting the supply cord from the power outlet. 3. When the power supply to the electric tool is disconnected for a short time, e. g. when moving the tool to a differenl workplace, the electric tool remains active and ready for use for approx. lf the power supply t0 the electric 3. 2 Using the company card to sel the TPS code and pr0gram the activati0n key simullaneously fl 1. Hold the c0mpany card against the lock symbol on the electric tool (position of the lock symbol is shown in the 0perating instructions for the tool) within one minute. Hold the activation key against the lock symbol on the electric tool (position of the lock symbol is shown in tool is interrupted for longer than 20 min. , the electric tool must be reactivated by way of the activation key. 3. 5 Using the company card l0 cancel the electric tool TPS code El 1. Hold the c0mpany card against the lock symbol on the electric tool (position of the lock symbol is shown in the operating instructions for the tool). C0mplete the TPS code canceling operation by disconnecting the supply cord from the power outlet. the operating instructions for the tool). The yellow lamp then lights constantly for 1 second before continuing to blink rapidly, 5. [. . . ] only original Hilti consumables, accessories and spare pads are used with the product. This warranty provides the free-of-charge repair or replacement of defective pafts only. Pafts requiring repair or replacement as a result of normal wear and tear are not covered by thls warranty. for repair or replacement. This constitutes Hilti's entire obligation with regard to warranty and supersedes all prior or contemp0raneous comments and oral 0r written a0reements concernino warranties. @+ @+ @+ @+ <- @+ [. . . ]